Header
Forums » Building and Using a Fab@Home Printer

Fabstudio software - start print problem

homemade - Posted on 20 February 2012

Hello.

I can't figure out what I've missed. I have needles ready - jogging, geometry imported and placed, fabrication "plan process" done ("slicing complete") but "Start Printing" command in fabrication menu stays inactive.

What to do?

‹ Hand Build Warning 'Jogging' Motors ›
..
Have you connected to the
Submitted by JeffreyILipton on Tue, 02/28/2012 - 18:17.

Have you connected to the device. you need to go hareware->connnect to hardware then hardware->emmulation->emulate haredware and turn off the hardware emulation. Only then will it print

Hi. are you using a model 2
Submitted by JeffreyILipton on Fri, 02/24/2012 - 05:21.

Hi. are you using a model 2 or 1?

Model is..
Submitted by homemade on Mon, 02/27/2012 - 10:25.

hi.

My first message was killed by spam-engine.

I'm using Model 1. After I have done "plan process" two items in the menu activates ("pause something" and "allow something"). "Start Printing" stays inactive.