Dremel Tool Vacuum Attachment

I have just completed the design of a vacuum attachment for the Dremel Tool holder. Before, it was often awkward to hold and maneuver a vacuum hose while milling a piece of foam or wood. Now, the holder can house an attachment for a Shop-Vac (for ease of vacuuming dust that results from milling). I found an attachment that is just the right size and provides the right amount of suction for gathering the dust of the materials commonly milled on the fabber. It can be purchased along with a set of other attachments here: http://www.shopvac.com/shopvac-accessories/Products/1-14-Micro-Cleaning-...

The vacuum attachment fits onto the end of a standard Shop-Vac hose and easily slides into the right side of the Dremel tool holder. It was a little tricky to get the correct size of the two holes and the height between the two side pieces projecting from the right side of the holder. As it is now, the attachment sits just low enough to provide enough suction, and just high enough as to not interfere with the piece sitting on the platform.

Entire fabber with vacuum hose attached

Front View

Black holder - Side View